Water heater earthquake strap requirements and code

What seismic strapping rules ask of a water heater: two straps placed on the upper and lower third of the tank, plus permits and inspection.

3 min read1 viewsWater heater earthquake strap requirements and code
— · 0 votes
Contents
  1. What the code asks of a tank
  2. Where the two straps go
  3. Permits, inspection and planning
  4. Questions about water heater strapping
  5. Do water heater earthquake straps have to follow a code?
  6. What are the water heater earthquake strap requirements for placement?
  7. Do I need a permit to strap a water heater?
  8. Can I strap a water heater myself?

Water heater earthquake strap requirements come from the building code your area has adopted, and the core rule is a pair of straps that hold the tank to the wall or framing. The straps sit on the upper and lower third of the tank, and a permit with an inspection often applies to the work. This page explains what the code asks for, where the straps go and how to plan the job.

What the code asks of a tank

Seismic strapping standards in the model residential code ask for a water heater to be anchored so it does not tip during shaking. The ICC International Residential Code, a model code that local governments adopt in whole or in part, carries these seismic strapping provisions. Your actual water heater anchoring rules are the version your jurisdiction has adopted and amended. Ask the local building department which edition applies before you buy hardware.

Where the two straps go

A tank held by straps needs two of them, one high and one low, so the cylinder cannot rock or slide. The upper strap wraps near the top of the tank and the lower strap wraps near the base, each within the upper and lower third of tank height. Both straps fasten to the wall or to framing that can carry the load, not to drywall alone. A plumber or a licensed contractor can confirm that the backing is solid enough.

Permits, inspection and planning

Adding earthquake straps to a water heater is construction work, so check with the building department about a permit and inspection. The permit and inspection step catches a strap that misses the framing or leaves the tank able to move. Keep the approval papers with your household records, next to the water heater manual. A trained specialist should do the strapping when the wall has no suitable backing or when the tank sits in a tight closet.

Questions about water heater strapping

Do water heater earthquake straps have to follow a code?

Yes, water heater earthquake straps follow the building code that your jurisdiction has adopted. The straps must meet the seismic provisions in that code, and the local building department enforces them. Confirm the adopted edition and any local amendments before the work starts.

What are the water heater earthquake strap requirements for placement?

Water heater earthquake strap requirements place two straps on the tank, one in the upper third and one in the lower third of its height. Each strap wraps the tank and fastens to the wall or framing. Hardware sold as a seismic strap kit is made for this two-strap layout.

Do I need a permit to strap a water heater?

A permit is often required for seismic strapping because the work is a structural attachment to the building. Rules differ by jurisdiction, so ask your building department whether a permit and inspection apply to your water heater. Keep the inspection record with your home papers.

Can I strap a water heater myself?

You can install straps yourself where local rules allow an owner to do the work, provided you fasten into solid framing. Straps fixed only to drywall or paneling will not hold the tank during shaking. Call a licensed plumber or contractor when the wall lacks backing or the space is cramped.

Read next

Latest articles