How to measure for a wheelchair ramp
Measure ramp rise, threshold height and available run so a wheelchair ramp fits the doorway and the space, including checks for a portable ramp.
Contents
- Measure the rise at the threshold
- Check the run and the landing space
- Match the numbers to the ramp rating
- Questions about measuring a wheelchair ramp
- How do I measure for a portable wheelchair ramp?
- What is the difference between ramp rise and ramp length?
- How do I work out the slope from my measurements?
- What should I check at the top and bottom of the ramp?
Measuring for a wheelchair ramp starts with two numbers: the rise, meaning how high the wheelchair must climb, and the run, meaning the flat distance available for the slope. You take the rise at the threshold or step, check the ground where the ramp will rest, and compare the two figures with the slope the ramp is rated for. The same steps work for a fixed ramp and for sizing a portable ramp, and writing the numbers down keeps the handover clear when someone else sets the ramp up.
Measure the rise at the threshold
The rise is the vertical height from the lower ground to the top of the surface the wheelchair will enter. Place a straight edge across the threshold and measure down to the ground with a tape, keeping the tape vertical. Threshold height can differ from one door to another, so measure each entry separately. Write the rise in the same unit you will use for the run.
Check the run and the landing space
The run is the horizontal distance the ramp can occupy, measured from the base of the rise to the point where the ramp ends. Slope is the rise divided by the run, so a short run forces a steeper ramp for the same rise. Measure the flat landing at the bottom as well, because a wheelchair needs room to turn before it starts up. Keep the path clear of steps, drains and soft ground that would shift under a portable ramp.
Match the numbers to the ramp rating
Every manufactured ramp states the slope it is built for, often as a ratio of rise to run. Compare your measured rise with that rating and work out the ramp length it calls for, then check that the length fits your run. A portable ramp must also reach the threshold with its lip seated flat and its feet on firm ground. Where the available run cannot meet the rated slope, ask a supplier or an access specialist about the options rather than forcing a steeper setup.
Questions about measuring a wheelchair ramp
How do I measure for a portable wheelchair ramp?
Measure for a portable ramp the same way as a fixed one, starting with the rise at the threshold and the run you can spare. Check that the folded or extended length of the portable ramp fits that run and that its lip rests flat on the threshold. Confirm the ramp is rated for your rise and that its feet sit on firm, level ground.
What is the difference between ramp rise and ramp length?
Ramp rise is the vertical height the wheelchair climbs, while ramp length is the distance the ramp covers along the ground. Slope links the two, because a longer ramp gives a gentler slope for the same rise. Measure both before you choose a ramp, since a ramp that is long enough for the rise may still not fit your space.
How do I work out the slope from my measurements?
Slope is the rise divided by the run, written as a ratio such as one unit of rise for a set number of units of run. Divide your measured rise by your measured run to get a decimal, then compare it with the slope the ramp is rated for. If your figure is steeper than the rating, you need a longer ramp or a different route.
What should I check at the top and bottom of the ramp?
Check that the top of the ramp meets the threshold with no lip or gap that could catch a wheel. At the bottom, confirm a flat landing with room to turn and stop before the wheelchair reaches the slope. Firm ground under the ramp base keeps a portable ramp from sinking or sliding during use.